A boat lift takes your hull cleanly out of the water at the end of every trip — no barnacles, no bottom paint, no salt-soaked lower units. We design, install, and service lifts from jet-ski platforms to 24,000 lb offshore rigs across Southwest Florida.
★★★★★ 5.0 · 5 Google reviewsLeave a boat in Southwest Florida's warm salt water and it goes to work against you — growth on the hull, blistering bottom paint, and electrolysis on every fitting. A properly engineered lift solves all of it and has your boat ready to drop and run in under a minute.
We build for this coast: marine-grade aluminum frames, 316 stainless cables and hardware, sealed marine motors, and cradles sized to your exact hull. Every install is permitted in-house and set to your seawall height and canal width.
Real installed ballpark ranges — your free on-site estimate is exact.
Premium spec is standard — marine-grade materials, 316 stainless, no good/better/best tiers.
We meet you at the water, measure, and scope the job.
City, county, and state permitting handled in-house.
Our crew, our equipment — communication every step.
We don't disappear — real warranty, local support.
Most lifts run from about $3,000 for a jet-ski lift to $8,000–$13,500 for a 7,000–10,000 lb lift, with larger offshore lifts $14,000 and up. Final price depends on pilings, canal depth, and electrical.
Size the lift to your boat's fully-loaded weight — hull, engines, fuel, and gear — plus a safety margin. We confirm the right capacity at a free on-site estimate.
Once permits are in hand, a standard install is typically a day or two on the water. Permitting timelines vary by jurisdiction.
In the Florida sun a canopy protects gelcoat, upholstery, and electronics, and keeps the boat cleaner between trips.
Rinse the cables and cradle, keep the boat balanced on the bunks, and service the lift annually. We build with aluminum, 316 stainless, and sealed motors so salt doesn't shorten its life.
Tell us about your project — we'll send a real number. Or call (239) 397-3400.